G'day all
Another small update, but this one I'm doing a step by step instructions for the newbies to modeling hobby.
I have also tweaked my method by adding one more step, but this will make it a lot less cluttered when doing the actual planking.
After both sides were dry fitted to the mold using my small Bulldogs clamps
and making both the bow
And the stern planks are even and joined flush.
I pinned my admiral's sewing pins into the ply bulkheads of the mold. Don't tell her please.
Now it was safe to remove the Bulldogs clamps to make the access to the mold easier.
Placing the plank back on the mold,
but dry fitting only I found that there was one irregular spacing between the planks.
The blue spot on the new plank doesn't match the red spot on the previous plank. I think it was my fault because I wasn't playing attention before now.
I marked a pencil line on the plank to where this plank should be trimmed to. I also make the start and finishing points and draw a line so I know how much and where to trim the plank.
As you can see there isn't much to trim.
Using a scaple blade as a planner I scrapped away the plank to almost to the line.
Luckily I did, as the dry fitting shows it was almost perfect.
I then planned and sanded the planks as described before.
The above photo try to shows how the end of the planks looked like after playing around with it.
This is very important: The transom on this model is not beveled, so I cut a V shaped grove on the inside of the plank,
so that there will be more surface area to glue the plank to the transom.
As you can see there is more surface area to glue the plank down.
As you can see, the results are semi effective on the bow, but I'm hoping to get better with practice.
Now the 5th plank has been fitted to both starboard and port sides.
I'm a bit embarrassed to say this, but it has taken me 2 hours just to do 2 planks, so at my 'snail rate' I should be finished the planking in another mere 10 hours.
Anyway, I'm having fun and I'm so glad to be back in the shipyard.
Thanks for watching and happymodeling to everyone.
Greg