Hello ship modellers,
I opened up a plank-on-bulkhead kit and set out to start with the bulkheads. The first thing I noticed was that the bulkhead former, the sheet that runs down the middle of the ship to hold the bulkheads, was slightly warped. It was cupped a bit lengthwise. I wouldn't expect that from plywood, but it is what it is.
Any advice on how to handle this? I have some ideas but would like to hear from the experts.
Thanks,
Glenn
I opened up a plank-on-bulkhead kit and set out to start with the bulkheads. The first thing I noticed was that the bulkhead former, the sheet that runs down the middle of the ship to hold the bulkheads, was slightly warped. It was cupped a bit lengthwise. I wouldn't expect that from plywood, but it is what it is.
Any advice on how to handle this? I have some ideas but would like to hear from the experts.
Thanks,
Glenn