I’ve been able to spend more time modeling yesterday and this morning. Normally I would dampen a plank, bend it and let it dry on it’s on. The last planks I bent two at a time and applied heat to dry them.
View attachment 440047
Clamps became useless as the gap narrowed. Now is where our individuality shows up, by coming up with all kinds of ideas that no one man can solve. To bad I’m not one of them
![Smile :) :)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
I went simple this time.
View attachment 440049
I tried to watch the keel, to make sure it stays as straight as it was after I broke the stem and had to glue it back together
View attachment 440050
The last two planks were 1.4 mm and 1.5 mm
View attachment 440052
I used a scrap end that I cut the bevel off of. Using the tapered end as my reference on which side I would be working on. So I wouldn’t work on all the sides
![Smile :) :)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
I used a small planer to get it close, and then sanded the rest of the way.
View attachment 440051
I did have to redo them several times.
View attachment 440053
View attachment 440054
Time to to cut it off the strong back.
View attachment 440055
Next I will be planking up both ends and the dozens of support ribs. I also covered the island with a thin coat of homemade paper clay.
View attachment 440048
I may paint a base coat on it next so I can think of what I need to do next on it. Thanks for viewing and comments are welcome
View attachment 440056