Make your own planking clamps. Plank on frame ships.

donfarr

Well-Known Member
Blandford Group Build
Joined
Jan 9, 2013
Messages
716
Points
63

#5
I have used these clamps from China have about 30 of them they work very good on pof builds, I THINK THEY ARE GREAT, to me i would rather spend the money and save the time of doing them myself, also there is a cost involved in the wood, machine screw waser and wing nut maybe small but it is there. Don
 

Brian077

Well-Known Member
Joined
Jul 9, 2016
Messages
655
Points
93

Location
Melbourne Australia
#6
Hi Don,
I found the wing nuts on the thin Chinese screws strip the thread easily when you tighten up the clamps, so I used a thicker diameter screw and wing nut.
 
Joined
Aug 2, 2018
Messages
25
Points
13

Location
Sydney, Australia
#8
Hi Don,
I found the wing nuts on the thin Chinese screws strip the thread easily when you tighten up the clamps, so I used a thicker diameter screw and wing nut.
What diameter screw did you use (mm)?
Do they fit in between your Enterprise frames?

I'm thinking of batching these out by getting the profiles right on pieces on long strips of wood then just cutting the strip across the width. I would expect that's how they do it in the factory.
I feel it'll take more time to sand the finished pieces than it takes to profile and cut them.
 
Top